Error F44 is a problem with the Bosch washing machine that starts to rotate the drum incorrectly.
In this article we will understand why the system gives an error and what to do to eliminate it.
Decoding, description and signs
If the Bosch washing machine shows the code F44 on the display, this indicates that the CM motor is rotating in the opposite direction.
The first and only sign that accompanies a breakdown in which F44 is lit on the display is a complete stop of the machine in the middle of the wash cycle. The washing machine does not respond to button presses.
Check
If washing Bosch shows an F44 error, try to fix the failure first by an elementary action - reboot. Just do it right:
- Disconnect the AGR from the mains.
- Wait 15-20 minutes.
- Turn on the typewriter.
If the code value is displayed again, then drastic measures are needed.
Machine repair with error F 44
Error codes - a very useful feature that helps the user quickly understand the essence. If you look at the user manual, there can even be a brief description of the solution to the problem.
In service centers they know what F44 means and how to eliminate the appearance of code on the board. Masters carry out such repairs:
- They change the triac.
- Change the reverse relay.
- Reprogram or change the electronic module (control board).
Important! This is a very critical mistake, which means that you need to act immediately. Your task is not only to remove the error, but also to eliminate the malfunction.
Resolving the reasons for the failure
For optimal operation of the washing machine motor, an electronic circuit is used in its design.
The power regulating element of this circuit is the triac. This small element supplies the necessary voltage to the engine. Simply put, a triac is a high-speed switch, and if it fails, the engine does not work correctly. In this case, a triac replacement is required.
The video for those who like to delve into the details of the machine shows how to check the triac:
To check the second cause of failure - the reverse relay, you need to know the device of the Bosch washing machine and have on hand the SMA circuitry.
The task is to find the relay, ring it with a tester and replace it in case of failure.
If the triac and relay are in order, a flashing or replacement of the control board is required.
All three types of work are quite specific. If you do not have repair skills, it is better to entrust the Bosch machine to a specialist.
Other causes of machine stop: how to fix
It happens that fault codes are just a system failure, it was displayed erroneously.
Sometimes CM does not display any codes, but still stops during the washing process. This may be the result of the failure of other nodes. Perhaps one of the following reasons will give you an understanding of how to fix the failure:
- Drum overload. Remove excess laundry.
- Tank imbalance. The laundry may have lumped in the wash. Unravel it.
- Blockages in the drain or flood system. It is necessary to clean the filters at the water inlet and outlet.
- Engine failure. Need analysis of washing machine, removal and repair of the engine.
- Breakdown tena. Heater replacement required.
- The problem of sensors.
You can try to eliminate the above causes with your own hands in order to reset the errors.
But if this is a difficult task for you, contact the specialists - they are well versed in the repair of Bosch washing machines.